2004 Ford F-150 Main Control Valve Body Disassembled View
download 1. Remove the torque converter clutch (TCC) solenoid and the shift solenoid. 1. Remove the retaining bolt. 2. Remove the shift solenoid. 3. Remove the TCC solenoid. 2. Remove the 2...
View Article1994 Ford Aerostar/Ranger/Explorer Camshaft Timing ADJUSTMENTS
download Checking Timing An access plug is provided in the cam drive belt cover so that camshaft timing can be checked without removal of the cover or any other parts. 1. Remove the access plug from...
View Article1996 Ford E 350 Van Exhaust Manifold – Exhaust Leaks
download An exhaust leak at the exhaust manifolds may be evident on some vehicles. This may be due to heat causing a reduction in bolt torque on the exhaust manifolds. ACTION Install new exhaust...
View Article1998 Ford Expedition Main Control Valve Body Removal Installation
download 1. If equipped, turn the air suspension switch OFF. 2. Disconnect battery ground cable. 3. Raise and support the vehicle; refer to Section 100-02. 4. Drain transmission fluid and remove the...
View Article1995 Ford Windstar VALVE CLEARANCE ADJUSTMENT
download NOTE: Hydraulic valve lifters are used; no valve adjustment is required. When valve and/or valve seat is machined, valve clearance is reduced and may cause improper valve operation. Different...
View Article1996 Mitsubishi Eclipse GS-T TIMING BELT & BALANCE SHAFT BELT Removal
download 1. Disconnect negative battery cable. Remove engine undercover. Place wooden block between jack and oil pan, and raise engine slightly. Remove engine mount assembly near timing belt cover. 2....
View Article2007 Chevrolet Impala 4T65E Transmission 1-2 Shift Shudder at Light to...
download Models: 2001-2004 Buick Regal 2001-2005 Buick Century, LeSabre 2002-2007 Buick Rendezvous 2005-2007 Buick Terraza, LaCrosse, Allure (Canada Only) 2006-2007 Buick Lucerne 2001-2005 Chevrolet...
View Article2003 TOYOTA TACOMA TIMING BELT INSTALLATION REMOVAL
download NOTICE: Always turn the crankshaft clockwise. (c) Check that the timing marks of the camshaft timing pul- leys and No.3 timing belt cover are aligned. If not, turn the crankshaft pulley 1...
View Article1992 Suzuki Swift VALVE CLEARANCE ADJUSTMENT
download NOTE: Samurai & Sidekick 1) Remove rocker cover. Rotate crankshaft until zero degree (TDC) timing mark of timing belt cover is in line with timing mark on crankshaft pulley. 2) Cylinder...
View ArticleVARIABLE VALVE TIMING (VVT) NOISE WHEN STARTING ENGINE 2007 Mazdaspeed 3...
APPLICABLE MODEL(S)/VINS 2007 Mazdaspeed3 vehicles with VINs lower than JM1BK******742222 (produced before April 1, 2007) 2006-2007 Mazdaspeed6 vehicles with VINs lower than JM1 GG******109660...
View Article
More Pages to Explore .....